Filter
Top Products
8
4. Hold the Left Upright (89) against the Base (94).
Be careful not to pinch the Upright Wire (81)
or the base ground wire (A). Insert two 3/8" x
1 1/4" Screws (8) with two 3/8" Star Washers
(13) and two 3/8" x 2 3/4" Screws (7) into the Left
Upright.
Partially tighten the 3/8" x 2 3/4" Screws (7) and
the 3/8" x 1 1/4" Screws (8) until the heads of the
Screws touch the Left Upright (89); do not fully
tighten the Screws yet. Note: Use the short hex
key.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the right
side.
89
94
4
81
8
7
13
13
3. Identify the Left Upright (89), which is marked
with a “Left” sticker or an “L” sticker. Have a sec-
ond person hold the Left Upright near the
Base (94).
See the inset drawing. Tie the wire tie in the
Left Upright (89) securely around the end of the
Upright Wire (81). Then, pull the other end of the
wire tie until the Upright Wire is routed through
the Left Upright.
81
3
81
89
Wire
Tie
Wire
Tie
89
94
81
A