Filter
Top Products
Assembling the Exercise Bike 17
4. Remove the four #10 x 1-inch self-tapping screws holding
the left side cover in place, then pull the cover away from
the body assembly. Guide the cover around the pedal
crank, then remove it and set it aside.
Figure 5: Side cover removal
5. Slide the jack panel out of its bracket in the right side
cover.
To install the upright support and prepare the cables for
connection to the console:
1. Remove the tape holding the base unit data cable in place
inside the upright support channel.
2. Proceed according to whether or not you are installing
Cardio Theater equipment on the console.
If ... Then ...
You are not installing Cardio Theater
equipment on the console
Skip to step 6.
You are installing Cardio Theater
equipment on the console
Continue with step 3.
3. Attach the lower ends of the following cables to the inner
side of the jack panel:
y Television cable
y Power cable
4. Slide the jack panel back into its bracket in the right side
cover.
5. Using a piece of tape or a plastic tie, bind together the
upper ends of all cables.
6. While your assistant holds the upright support in place
over the body assembly, thread the cable or cables
upward through the support. When you are finished, use a
piece of tape to secure the upper connectors of the cables
at the top of the support.