Filter
Top Products
24 Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 883 / 833
8. Pull the end of the cable upward through the opening just
behind the lift motor, as shown in the previous illustration.
9. Locate the tabbed end of the modular plug coupler. Snap
this end of the coupler into the square opening in the jack
panel.
10. Slide the quick-disconnect terminal on the grounding lead
of the power cable over the grounding terminal on the
equipment frame.
11. Attach the cable to the appropriate connector inside the
base of the EFX, as shown in the following illustration and
table.
Important: Install coaxial cable using a torque wrench and
torque to not exceed 8 lb-in. If a torque wrench is not
available, install the coaxial cable using a wrench to “snug +
¼ turn.” It is permissible to use a wrench on the internal nut
to aid the tightening process.
Figure 6: Cable connection points inside EFX base