Precor C940 Home Gym User Manual


 
COMMERCIAL PRODUCTS DIVISION
4. Place the center clamp on the front portion of the handrail, followed by an end
clamp. See Diagram 2. Align the two clamps with the handrail mounts on the
upper frame.
5. Insert a bolt through each clamp. See Diagram 2. Using the supplied 3/16"
hex key, screw each bolt through the handrail until the clamp is snug against
the upright support. Do not fully tighten the bolts until you have installed the
lower end of the handrail.
6. To mount the lower portion of the handrail, locate the lower handrail clamp,
star washer, and lower handrail clamp bolt. Refer to Diagram 3 while taking
the following steps:
Note: If you are installing both handrail options, perform the following
steps on one side of the treadmill before proceeding to the other side.
a. Slide the handrail nut plate along its guide rail until the hole in the nut
plate is aligned with the handrail mounting hole.
b. Put one star washer on the lower handrail clamp bolt. For ease of
assembly, set the bolt on the floor near the nut plate.
c. Place the lower portion of the handrail into the clamp and align the bolt
hole.
d. Pick up the bolt set aside in step 6b. and insert the bolt through the lower
handrail clamp and handrail mounting hole.
e. Guide the lower handrail clamp onto the nut plate. Slide the clamp and
nut plate along the guide rail to find the equilibrium point.
Attaching the lower handrail
and handrail clamp.
Diagram 3
Handrail
Nut plate
Lower handrail clamp