Filter
Top Products
EFX5.21/ 5.23 Elliptical Fitness CrossTrainer Assembly Guide 4
Cut any wire ties that secure the cable to the stabilizer. Unwrap the
cable and remove any kinks. Feed the cable through the console
bracket as shown in the illustration.
Slide the console bracket into the right stabilizer and align the
three mounting holes. Insert the top two buttonhead screws (C)
with lock washers (D). Partially tighten.
CAUTION: Make sure you do not pinch the cables while attaching
the console bracket. Any damage caused during installation is
not covered by the Precor Limited Warranty.
Insert the bottom buttonhead screw (C) with lock washer (D).
Partially tighten.
Slide the left stabilizer onto the console bracket and secure its
base using four hex head screws (A) and four washers (B). Partially
tighten.
Note: You may need to pivot the stabilizer back and forth to fit it
snugly onto the console bracket.
Return to the console bracket and insert the three remaining
fasteners. Fully tighten all six console bracket fasteners.