Polar CE2.7 Elliptical Trainer User Manual


 
‐25‐
CE2.7EllipticalTrainer
Visitusat:www.smoothfitness.com
COMPUTER INSTRUCTIONS
POWER ON
After connecting the power cord switch the power button on. The LCD screen will light up.
To switch back to the power on status after the machine has already been used press the stop button twice.
QUICK START
When the computer is in the POWER ON STATUS, press the start button to activate the QUICK START program,
the TIME, DISTANCE and CALORIES will count up when you start exercising.
SLEEP MODE
When the power is ON the computer will automatically enter SLEEP MODE if it is left idle for 3 minutes without
receiving any input, press any button to return to power on status when the computer is in the SLEEP MODE.
PAUSE MODE
While in the PROGRAM, without pedalling the machine for 30 seconds, the speed sensor located inside the
machine cannot detect any RPM signal, the console will enter the PAUSE MODE. During the PAUSE MODE, if
you start pedalling the machine or press the START button, the console will return to the PROGRAM MODE and
continue the original program. Press the STOP button to PAUSE the program, press STOP button twice and the
LCD will return to POWER ON status.
PROGRAM
To select one of the User programs, you will need to select the USER CODE first, press the UP/DOWN button to
select the USER CODE from U1 to U9. This is shown in the SPEED display. Press the ENTER button to confirm
the USER CODE. If the user information has been previously input, press ENTER button and hold for 5 seconds,
The computer will then skip the user information set up procedure and enter the program select procedure. To
input new information, please follow the below procedure.