Filter
Top Products
607/608 FACTOR 625 D-RING RETRO KIT ASSEMBLY INSTRUCTIONS
3.
Replace the remaining CABLES in the following’or~er using the steps outlined in STEP 2: (PLEASE
REPLACE ONE CABLE AT A TIME, REPLACING IN A CLOCKWISE DIRECTION AROUND
THE D-RING. SEE DRAWING)
¯
PEC/D-RING CABLE (6406101)
¯
MULTI PRESS CABLE (6405801)
¯
LAT CABLE (6405901)
When all of the CABLES have been replaced, adjust the height of the D-RING on the D-RING CABLE
by raising or lowering the two (2) 1/4-28 IN. NUTS. (THE D-RING SHOULD REST JUST BELOW
THE D-RING CABLE CLIPS ON THE CABLE ENDS). When the correct height is obtained.
SECURELY tighten the two (2) 1/4-28 nuts together.