Filter
Top Products
8
2. Attach the four Base Pads (81) (only three are shown) to
the base of the Uprights (85) with four 1” Tek Screws (82)
a
nd four Plastic Spacers (101). Note: One replacement
Base Pad may be included. Use the Base Pad to replace
a
ny Base Pad that becomes worn.
With the help of a second person, carefully tip the tread-
mill down so the four Base Pads (81) are resting on the
floor and the Uprights (85) are in a vertical position.
85
8
2
82
81
81
1
01
101
101
55
2
3. Remove the band securing the Upright Wire Harness (73)
to the right Upright (85). Have a second person hold the
console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the wires ex-
tending from the console assembly. Make sure to con-
nect the connectors properly (see the inset drawing).
The connectors should slide together easily and
snap into place. If the connectors do not slide together
easily and snap into place, turn one connector and try
again. IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON. Insert the connec-
tors into the right Upright (85).
73
85
Console
Assembly
73
3
4. Remove the band securing the TV Cable (115) to the left
Upright (85). Connect the TV Cable to the cable extend-
ing from the console assembly. Then, insert the TV Cable
into the left Upright.
115
85
Console
Assembly
4