Filter
Top Products
30
H
OW TO USE THE INFORMATION MODE
The console features an information mode that allows
you to view treadmill usage information, select a sys-
t
em of measurement for the console, and turn on and
t
urn off the demo mode. The information mode also al-
lows you to adjust the settings of the television and to
save channels into the television’s memory.
Follow the steps below to use the information mode.
Hold down the Stop button while inserting the
key into the console.
When the information mode is selected, the dis-
play will show the total number of hours that the
treadmill has been used and the total number of
miles or kilometers that the walking belt has
moved.
In addition, the display will show the word ENG-
LISH or METRIC to indicate which system of mea-
surement is selected. To change the system of
measurement, press the Speed increase button.
The display will also show the words DEMO
MODE and the current setting: OFF, LOGO,
ROAD, or PROGRAMS (see step 5 on page 16).
To change the setting, press the Speed decrease
button repeatedly.
Press the Power button and adjust the
brightness, contrast, color, sharpness, and/or
hue of the television.
When the Power button is pressed, the brightness
level indicator will appear on the television screen.
Press the Volume buttons to adjust the brightness
setting if desired.
Next, press the Channel buttons until the contrast,
color, sharpness, or hue level indicator appears.
Adjust the settings, if desired, by pressing the
Volume buttons.
Press the Power button again and add or
delete channels.
After all valid channels available in your area have
been saved into the television’s memory (see step
5 on this page), you can manually add channels
or delete unwanted channels.
To add or delete a channel, first press the
C
hannel buttons until the desired channel number
appears on the screen. Then, press the Volume
increase button to add the channel, or the Volume
decrease button to delete the channel. Continue
this process until you have added all desired
channels and deleted all unwanted channels.
Press the Power button again and select an
antenna connection or a cable connection.
After the Power button is pressed, press the
Volume decrease button to select the Air setting,
the Volume increase button to select the Standard
Cable setting, the Channel decrease button to se-
lect the Cable IRC setting, or the Channel in-
crease button to select the Cable HRC setting.
Note: The setting that you select will
not appear
on the screen. If you have connected an antenna
to the treadmill, the Air setting should be selected.
If you have connected a CATV cable, one of the
three Cable settings should be selected; try all
three Cable settings, if necessary, to find the opti-
mal setting.
Press the Power button again and save
channels into the television’s memory.
When the Power button is pressed, the television
will begin scanning all of the channels available in
your area. When no broadcast signal is detected
on a channel, the channel will be skipped. When a
broadcast signal is detected, the channel will be
saved into memory and the next channel will be
selected. This process will continue until the high-
est channel is reached. Do not remove the key
while the television is scanning channels.
When you are finished using the information
mode, remove the key.
To exit the information mode at any time (except
while the television is scanning channels), remove
the key from the console.
6
5
4
3
2
1