Filter
Top Products
22
Inspect and properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. Keep liquids away from the console
and keep the console out of direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the right side shield must first be removed.
Remove the indicated M4 x 25mm Screws (65) from
the Left Side Shield (26).
Next, remove the indicated M5 x 25mm Screw (93)
and M4 x 16mm Screws (57) from the Right Side
Shield (27). Using an adjustable wrench, turn the
Right Pedal (21) counterclockwise and remove it. Turn
the Right Crank Arm (23) so that it is pointing toward
the front of the exercise cycle, and then slide off the
Right Side Shield.
Locate the Reed Switch (46). Turn the Right Crank
Arm (23) until the Magnet (30) is aligned with the
Reed Switch. Loosen, but do not remove, the indicat-
ed M4 x 16mm Screw (57). Slide the Reed Switch
slightly closer to or away from the Magnet. Then,
retighten the Screw. Turn the Right Crank Arm for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the right side shield and the right pedal.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the Drive Belt (47) may need to be adjusted. To
adjust the Drive Belt, you must first remove the right
side shield. Refer to HOW TO ADJUST THE REED
SWITCH at the left and remove the right side shield.
Next, turn the indicated M10 Nylon Locknut (63) until
the Drive Belt (47) is properly tightened. Then, reattach
the right side shield.
PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper-
ly, refer to step 5 on page 13.
MAINTENANCE AND TROUBLESHOOTING
57
21
23
63
27
46
23
57
30
47
93
57
65
26
65