Filter
Top Products
7
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8. Identify the Left Pedal (22), which is marked with an
“L.” Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the Left Crank Arm
(24). Tighten the Right Pedal (not shown) clockwise
into the Right Crank Arm. Important: Tighten both
Pedals as firmly as possible. After using the
exercise cycle for one week, retighten the
Pedals. For best performance, the Pedals must
be kept tightened.
Identify the Left Pedal Strap (25), which is marked
with an “L.” Attach the Left Pedal Strap to the Left
Pedal (22), and adjust it to the desired position.
Adjust the Right Pedal Strap (not shown) in the
same way.
8
22
24
25
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Remove the four recessed screws (not shown) from the
underside of the Console (4). Do not remove the
screws attaching the Console to the metal plate on
the Handlebar (3).
Push the two water bottle holders up out of the
Console (4).
Carefully lift the fan and the top of the Console (4) in
the locations shown at the right; do not let the fan
slide out of the top of the Console. Note: It will be
necessary to turn the top of the Console slightly to
lift it past the Handlebar (3).
2. While another person holds the top of the Console (4)
and the fan in a vertical position, slide the receiver onto
the indicated plastic pin on the Console; make sure
that the receiver is oriented exactly as shown.
Locate the two small screws included with the chest
pulse sensor. Attach the receiver to the Console with
the two screws as shown.
Connect the wire on the receiver to the indicated wire
on the Console (4).
Refer to step 1 above. Lower the top of the Console (4)
and the fan. Make sure that no wires are pinched.
Reattach the top of the Console with the four screws
removed in step 1. Discard any extra wires included
with the chest pulse sensor.
Pin
Wire
Screws
4
3
4
Lift Here
Water
Bottle
Holder
Water
Bottle
Holder
1
Receiver
2