Filter
Top Products
16
67
ATTACHING THE ACCESSORIES
T
o attach a Short Handle (67) to a high pulley, first
attach the high pulley to the resistance system (see
A
TTACHING THE HIGH PULLEYS on page 15). Then,
attach the Short Handle to the Short Cable (60) with a
Cable Clip (64).
The Long Handles (not shown) and the Ankle Strap
(not shown) can be attached to the long cable (not
shown) with Cable Clips (64). Attach the Leg Press
Strap (not shown) to both ends of the long cable, or the
optional lat bar to the Short Cables (60), with two
Cable Clips.
Note: A lat bar is an optional accessory for the
resistance system. To purchase a lat bar, call our
Customer Service Department toll-free at 1-888-825-
2588 and ask for model number WEMC0554.
60
60
64
32
Hook
109
62
64
53
+ / – Switch
ATTACHING THE LEG LEVER
To use the Leg Lever (32), attach the two ends of the
Leg Lever Cable (62) to the ends of the long cable (C)
with two Cable Clips (64).
Detach the Leg Lever Cable (62) from the Lower
Cable (109) when the Leg Lever (32) is not in use.
Store the ends of the Leg Lever Cable on the hook
under the Bench Rail (23).
ADJUSTING THE RESIST
ANCE
To change the resistance setting, press the + / –
switch on the Console (53). The display will show the
current resistance setting.
The resistance can be
increased up to 240 pounds.
Note: While the
resistance setting is changing, the
motor will be heard.
T
o prevent damage to the
motor, do not pull any of the cables while the
resistance setting is changing.
Note:
The resistance system
uses progressive resist
-
ance.
As the resistance bar begins to bend, the
amount of resistance will increase gradually. As the
bar bends further, the resistance will increase rapidly.