Filter
Top Products
7
4. Insert the Weight Tube (11) into a Weight (17).
Make sure the side of the Weight Tube with
t
he dimple holes is facing the indicated slot in
the Weight. Make sure the indicated slot in the
W
eight is oriented as shown. C
enter the Roll
Pin (54) into the indicated hole in the Weight
Tube. Note: The Roll Pin must be below the
Weight.
5. Orient the two Weight Guides (10) with the indi-
cated hole closer to the bottom (see the inset
drawing).
Insert the two Weight Guides (10) into the indicat-
ed holes in the Base (1). Attach the Weight
Guides with two M8 x 115mm Bolts (76), four M8
Washers (72), two 38mm Spacers (48), and two
M8 Nylon Locknuts (74).
Slide the two Weight Bumpers (50) onto the
Weight Guides (10). Next, slide eleven Weights
(17) onto the Weight Guides one at a time.
Make
sure the indicated slot in each Weight is ori-
ented as shown.
Then, slide the Weight Tube
(11) and Weight (17) onto the Weight Guides.
Apply the included weight decals (not shown) to
the Weights (17). The decal with the smallest
number should be applied to the top Weight; the
decal with the largest number should be applied
to the bottom Weight.
5
4
11
54
17
10
17
Slot
Slot
Weight
Decal
Holes
17
50
74
72
1
48
72
76
11
10
Dimpled Holes