Filter
Top Products
7
4. Cut the tie securing the Pulse Wire (74) to the right
Upright (20). Hold the Pulse Bar Assembly (69) near the
crossbar on the Upright. Connect the Pulse Wire to the
wire in the Pulse Bar Assembly. The connectors should
slide together easily and snap into place. If they do
not, turn one connector and try again. Insert the wires
into the crossbar.
Open parts bag B. Attach the Pulse Bar Assembly (69) to
the crossbar on the Upright (20) with four Pulse Bar Bolts
(13) and Star Washers (67). Start all four Pulse Bar Bolts
before tightening them. Make sure that no wires are
pinched.
Crossbar
74
13
13
69
20
67
67
74
4
2. With the help of a second person, raise the Upright (20) to
the vertical position.
Remove the knob from the pin. Make sure that the collars
a
nd the spring are on the pin as shown.
Press the Latch Insert (77) into the left side of the Upright
(20) as shown. Use a rubber mallet if necessary. Insert the
pin into the Latch Insert. Tighten the knob back onto the
pin.
77
2
Knob
20
Pin
Collar
Spring
3. With the help of a second person, raise the Walking
Platform (15) to the storage position and make sure that
the latch pin is engaged as described on page 28.
Position the Base Plate (126) on the treadmill as shown.
Attach the Base Plate with the three Base Plate Bolts
(125). Note: It may be helpful if a second person tips the
treadmill slightly as you tighten the Bolts.
If the treadmill rocks slightly, turn one or both of the
Leveling Feet (130) under the Upright (20) until the rock-
ing motion is eliminated (see page 31). Carefully lower
the Walking Platform (15) to the floor as described on
page 29.
126
15
125
20
130
130
3