Filter
Top Products
9
6. Attach the Latch Housing (34) to the left Upright
(20) with two Screws (7); start both Screws
and then tighten them. Make sure that the
large hole in the Latch Housing is on the indi-
cated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Next, insert the pin into the Latch
Housing (34). Then, tighten the knob onto the
pin.
6
7. With the help of a second person, raise the
Walking Platform (15) to the storage position and
make sure that the latch pin is engaged as de-
scribed on page 26.
Position the Base Plate (75) on the treadmill as
shown.
Attach the Base Plate to the Uprights
(20) with three Base Plate Bolts (77). Note: It
may be helpful if a second person tips the tread
-
mill slightly as you tighten the Base Plate Bolts.
Carefully lower the Walking Platform (15) to the
floor as described on page 27.
7
75
15
77
20
7
Pin
Spring
Collar
Knob
34
20
Large Hole
5. Carefully set the console assembly on the
Uprights (20) as shown. Make sure that no
wires are pinched. Attach the console assem-
bly with four Star Washers (67) and four Handrail
Bolts (72). Start all four Handrail Bolts and
t
hen tighten them.
5
72
20
67
67
Console Assembly