Filter
Top Products
8
2. Insert the Right Upright (74) into the indicated bracket on
the Base (83); be careful not to dislodge the Cage
Nuts (76 [see the inset drawing]) from the Right
Upright; in addition, be careful not to pinch the
Upright Wire Harness (75). Finger tighten three Upright
Bolts (72) with three Washers (78) and three Upright Star
Washers (71) into the bracket and the Right Upright. Do
not tighten the Upright Upright Bolts yet.
Repeat this step with the Left Upright (73).
2
74
83
72
72
78
73
71
Bracket
71
75
78
76
4
5
48
3. Attach the Catch (5) to the left side of the Frame (48) with
two 3/4” Screws (4).
3
4. With the help of a second person, raise the Frame (48) to
a vertical position. Be careful not to raise the Frame
past the vertical position. Have the other person hold
the Frame until step 5 is completed.
Identify the Gas Spring (88). Note that the Gas Spring
has a cylinder end and a piston end. See the small inset
drawings. Locate the Spring Pin (102) in the cylinder end
of the Gas Spring. Using your fingernail or the end of a
screwdriver, press on the end of the Spring Pin, rotate
the Spring Pin, and then pull the Spring Pin out of the
Gas Spring. Do not lose the Spring Pin. Note: Extra
Spring Pins are included in the literature bag.
Next, hold the cylinder end of the Gas Spring (88) near
the indicated bracket beneath the Frame (48). Press the
end of the Gas Spring as far as possible onto the ball on
the bracket. See the large inset drawing. Insert the
Spring Pin (102) into the indicated small holes in the end
of the Gas Spring, and rotate the Spring Pin until it clips
onto the Gas Spring.
102
48
88
Bracket
Cylinder
Piston
102
102
Left side of
Treadmill
88
Hole
Hole
102
Bracket
4