Filter
Top Products
7
5. Insert two Handrail Bolts (78) with Handrail Washers (77)
into the right Upright (69) and the right Handrail (66). Be
careful not to damage the Upright Wire Harness (not
shown). Next, lift the right Handrail (66) slightly and align
the Bolts with the holes in the Handrail. Thread the Bolts
into the Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Then, tighten all four Handrail Bolts (78).
6. Make sure that all parts are properly tightened before
you use the treadmill. Place a mat beneath the tread-
mill to protect the floor.
For your benefit, familiarize
yourself with the information on pages 27 and 28.
5
78
69
77
4. Cut the plastic tie holding the Upright Wire Harness (98)
in the right Upright (69). Have a second person hold the
Handrails (66) near the Uprights as shown. Connect the
Upright Wire Harness to the wire harness extending from
the Console Base (81).
The connectors should slide
together easily and snap into place. If they do not,
turn one connector and try again. Then, insert the con-
nectors and the Upright Wire Harness into the hole in the
right Upright. Set the Handrails on the Uprights, being
careful not to pinch the wires.
98
69
66
81
4
66
If you purchase the optional chest pulse sensor (see
page 24), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove
the indicated screws from the Console Back (A).
Important: The screws may be different lengths. Keep
track of which screws were removed from which holes.
Remove the Console Back.
2. Peel the paper off the pad on the bottom of the Receiver
(B). Turn the Receiver so the cylinder is on the side
shown, and press the Receiver into the bottom of the
Console Base (D) in the indicated location.
A
C
Screws
1
2
D
B
Cylinder
3.
Connect the included Short Jumper Wire (E) to the wire on
the Receiver (B). Connect the other end of the Short
Jumper Wire to the PLS2 jack on the back of the Console
(C). If there is a wire already plugged into the PLS2 jack,
unplug it. Note: The other wires included with the receiver
may be discarded. The wire tie can be used to tie wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (C) with the screws. Important: If the
screws are not put back into the same holes from which
they were removed, the Console will be damaged.
C
B
E
PLS2
Jack
3