NordicTrack NTL19007.0 Treadmill User Manual


 
21. Do not attempt to raise, lower, or move the
t
readmill until it is properly assembled. (See
A
SSEMBLY on page 6, and HOW TO FOLD
AND MOVE THE TREADMILL on page 25.) You
must be able to safely lift 45 lbs. (20 kg) to
raise, lower, or move the treadmill.
22. Do not change the incline of the treadmill by
placing objects under the treadmill.
23. When folding or moving the treadmill, make
sure that the frame is locked in the storage
position.
24. Inspect and properly tighten all parts of the
treadmill regularly.
25. Never insert or drop any object into any
opening on the treadmill.
26. DANGER: Always unplug the power
cord immediately after use, before cleaning
the treadmill, and before performing the main-
tenance and adjustment procedures de-
scribed in this manual. Never remove the
motor hood unless instructed to do so by an
authorized service representative. Servicing
other than the procedures in this manual
should be performed by an authorized service
representative only.
27. The treadmill is intended for in-home use
o
nly. Do not use the treadmill in any commer-
cial, rental, or institutional setting.
28. To protect the treadmill and TV during light-
ning storms, unplug the power cord from the
w
all outlet and disconnect the cable system.
This will prevent damage due to lightning and
power line surges.
29. To reduce the risk of electric shock, do not re-
move the cover or the back of the television.
There are no user serviceable parts inside.
Refer servicing to qualified service personnel.
30. Upon completion of any service or repairs to
the treadmill or the television, ask the service
technician to perform safety checks to con-
firm that the unit is in proper operating condi-
tion.
Note to CATV system installer: This reminder
is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.
4
SAVE THESE INSTRUCTIONS
Power Lines
Ground
Clamps
75 Ohm Terminal
Service
Entrance
Equipment
Power Service Grounding
Electrode System (e.g.
Interior Metal Water Pipe)
Service
Entrance
Conductors