Filter
Top Products
7
5. Insert two Handrail Bolts (104) with Handrail Spacers
(106) into the right Upright (99) and the right Handrail
(83). Be careful not to pinch the wires. Make sure that
the Handrail Spacers are flush against the right Upright,
with the thick sides facing the center of the treadmill, as
shown in the inset drawing. Next, lift the right Handrail
(83) slightly and align the Bolts with the holes in the
Handrail. Thread the Bolts into the Handrail. Do not
tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Then, tighten all four Handrail Bolts (104).
6. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor. For your benefit, familiarize yourself with the information on pages 28 to 30.
5
104
99
106
4. Cut the plastic tie holding the Upright Wire Harness (119)
in the right Upright (99). Have a second person hold the
Handrails (83) near the Uprights. Connect the Upright
Wire Harness to the wires extending from the Console
Base (56). The connectors should slide together eas-
ily and snap into place. If they do not, turn one con-
nector and try again. Then, insert the connectors and
the Upright Wire Harness into the hole in the right
Upright. Set the Handrails on the Uprights, being careful
not to pinch the wires.
99
56
83
4
119
Thick
Side
106
83