Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver and
wire cutters . For help identifying the assembly hardware, see the hardware drawings below.
1. With the help of a second person, carefully raise the
Uprights (20) and the Walking Platform (15) to the posi-
tion shown.
While the other person holds the Uprights (20) and the
Walking Platform (15), slide the Base Extension (90)
onto the two brackets on the base of the Uprights. Make
sure that the Base Extension is turned so the Base
Pads (81) are beneath it.
Note: It may be helpful to tip
the Uprights forward as you insert the Base Extension.
6
1” Tek Screw (82)–4
Console Bolt (72)–2
Pulse Bar Bolt (66)–4
Short Console
Bolt (112)–2
Star Washer (67)–8
3/4” Screw (7)–2
Extension Screw
(87)–4
81
Brackets
81
20
15
90
1