Filter
Top Products
ASSEMBLY
A
ssembly requires two persons.
S
et the treadmill in a cleared area and remove all packing materials.
D
o not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver ,
adjustable wrench , and rubber mallet . For help identifying the assembly hard-
ware, see the drawings below.
The number in parentheses below each drawing is the key number of the part,
from the PART LIST on pages 30 and 31. The number following the parentheses is the quantity needed for assem-
bly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if
it has been pre-assembled.
6
w (123)–2
1/2” Silver Screw
(48)–1
3/4” Tek Screw (58)–4
3
Spacer Screw (60)–2
1
1” Tek Screw (82)–4
Console Bolt (72)–4
3
Extension Leg Bolt (87)–4
Star Washer (67)–8
Plastic Spacer
(101)–4
Extension Leg
Nut (106)–4
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto its side as shown. Partially fold the Frame
(55) so the treadmill is more stable. Do not fully fold
the treadmill until it is completely assembled.
Insert an Extension Leg (97) into the indicated bracket
on the base of the Uprights (85). Make sure that the
Extension Leg is turned so the Base Pad (81) is on the
side shown. If necessary, use a rubber mallet to align
the holes in the Extension Leg with the holes in the
bracket.
Attach the Extension Leg (97) with two Extension Leg
Bolts (87), two Star Washers (67), and two Extension
Leg Nuts (106) as shown.
Firmly tighten the
Extension Leg Bolts.
With the help of a second person, carefully tip the tread-
mill onto its other side. Attach the other Extension Leg
(97) as described above.
85
55
Bracket
97
1
106
87
67
81
97