Filter
Top Products
6
Assembly
Assembly requires two people. Set the TREKKER in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own Phillips screwdriver .
Note: The underside of the walking belt is coated with high-performance lubricant. During shipping, a small
amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal con-
dition and does not affect performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant
with a soft cloth and a mild, non-abrasive cleaner.
1. Feed the Upright Wire Harness (100) through one of the
Uprights (23) as shown. Make sure that the smaller end
of the Upright Wire Harness (see the inset drawing) is at
the bottom of the Upright. Slide an Upright Collar (54)
onto the Upright. Note: The Upright with the Upright Wire
Harness is the right Upright.
100
54
23
1
3. Slide the Upright Collar (54) down to the position shown.
Finger tighten the three Upright Bolts (33) with Upright
Washers (32) into the right Upright (23). Note: It may be
necessary to move the Upright slightly to align the holes.
Attach the other Upright (not shown) in the same way.
Note: There is not a wire harness in the other Upright.
Do not tighten the Upright Bolts (33) yet.
3
23
32
32
33
33
54
2. If there are three Upright Bolts (33) in the right post on
the Base (101), remove them.
While a second person holds the right Upright (23) in the
position shown, connect the Upright Wire Harness (100)
to the Base Wire Harness (41) in the right post on the
Base (101). Insert both Wire Harnesses into the post.
Make sure that the right Upright (23) is turned as shown in
drawing 1. Slide the right Upright onto the right post on
the Base (101) and align the indicated holes. Be careful
not to pinch the Wire Harnesses (100, 41).
23
101
Hole
Hole
Holes
100
41
33
33
2
33
Holes