Filter
Top Products
12
25. Attach the Right Support (14) to a Weight Rest
Arm (13) with two M10 x 25mm Screws (56).
Rest the Weight Rest Arm (13) on the right
Upright (4).
Repeat this step with the other Weight Rest
Arm (13) and the Left Support (not shown).
26. Make sure all parts of the weight rack are properly tightened. In addition, pull each cable a few times
to make sure the cables move smoothly over the pulleys. If the cables do not move smoothly, locate
and correct the problem. When weights are used, the cables may be damaged if they are incorrectly
routed. Refer to the CABLE DIAGRAMS on page 15 for correct cable routing.
The use of all remaining parts will be explained in ADJUSTMENTS, beginning on the following page.
25
13
4
14
56
24. Wrap the Long Cable (43) around a 3 1/2” Pulley
(34). Attach the Pulley and a Cable Trap (36) to
the Center Top Frame (9) with an M10 x 47mm
Button Head Bolt (60), an M10 Washer (62), and
an M10 Nylon Locknut (64). Make sure that the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley and that the Cable Trap
does not contact the Cable.
24
43
64
62
60
36
34
9