Filter
Top Products
6
3. Press a 75mm x 50mm Inner Cap (21) into the
top of the Hack Squat Upright (4).
Remove the indicated two M10 x 45mm bolts (E),
two M10 washers (F), and two M10 Nylon
Locknuts (C) from the left upright (G).
Attach the Hack Squat Upright (4) to the two M10
x 67mm Carriage Bolts (33) in the Hack Squat
Base (1) with two M10 Locknuts (32). Do not
tighten the Locknuts yet.
Attach the Hack Squat Upright (4) to the left
upright (G) with two M10 x 50mm Bolts (39) and
two M10 Nylon Locknuts (C).
2. Press a 50mm Square Inner Cap (25) into the
indicated end of the Hack Squat Base (1).
Insert four M10 x 67mm Carriage Bolts (33) up
through the bottom of the Hack Squat Base (1).
Slide the Hack Squat Base into the rear base (C).
Note: If the Bolts fall out, stick a piece of tape
over the bolt heads to hold them in.
Secure the Hack Squat Base (1) to the rear base
(D) with four M10 x 25mm Bolts (31).
1.
Remove the 50mm x 75mm inner cap w/ slot (A),
the four M10 x 67mm carriage bolts (B), and the
four M10 nylon locknuts (C) from the rear base
(D).
Before beginning assembly, make sure that
you understand the information on page 5.
This brief introduction will save you much
more time than it takes to read it.
Frame Assembly
1
C
D
BB
33
25
31
D
1
A
3
33
32
4
21
32
33
1
G
F
E
C
39
2