Filter
Top Products
78
77
Thick
Side
Console
Assembly
69
77
4
7
5. With the help of a second person, carefully tip the
Uprights (69) down to the position shown. Make sure that
the Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two 1” Screws (47)
and a Base Pad (99) as shown. Note: Attach the lower
Screw (without the Base Pad) first.
Next, align the lower ends of the Handrails (118) with the
holes in the base of the Uprights (69). Attach each
Handrail with a 4” Bolt (53) as shown. Note: The Bolts
must be at an angle that matches the angle of the
Handrails, as shown in the inset drawing.
Note: A replacement Base Pad (99) may be included. Use
the Base Pad to replace any Base Pad that becomes worn.
47
53
53
102
118
69
99
47
102
99
99
99
99
99
5
3. Cut the rubber band securing the Upright Wire Harness
(98). Have a second person hold the console assembly
near the Uprights (69). Connect the Upright Wire Harness
to the wires extending from the Console Base (81). The
connectors should slide together easily and snap into
place. If they do not, turn one connector and try again.
Insert the connectors and the Upright Wire Harness down
into the right Upright, and then set the console assembly
on the Uprights. Be careful not to pinch the wires.
98
69
81
Console
Assembly
3
98
118
53
4. Insert a Handrail (118) into the right side of the console
assembly as shown. (Note: It may be helpful to twist the
Handrail as you insert it.) Next, insert two 4 1/2” Bolts (78)
with Handrail Spacers (77) into the right Upright (69) and
the Handrail. Be careful not to pinch the wires. Make
sure that the Handrail Spacers are flush against the right
Upright, with the thicker sides of the Handrail Spacers
toward the center of the treadmill, as shown in the inset
drawing.
Next, lift the console assembly and the Handrail (118)
slightly and align the 4 1/2” Bolts (78) with the holes in the
Handrail. Thread the Bolts into the Handrail until the
heads of the Bolts are against the right Upright (69). Do
not tighten the Bolts yet.
Attach the other Handrail (not shown) in the same way.
Note: There are no wires on the left side.
118