Filter
Top Products
7. Make sure that all parts are tightened before you use the treadmill. Note: If there is a thin sheet of clear
plastic on the hood decal or the “ComforTrack” decal, remove it. Keep the included allen wrench in a secure
place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from
damage, place a mat under the treadmill.
5. Insert two Handrail Bushings (75) into the right Upright
(69). Turn the Handrail Bushings so they fit against the
Upright with the thick sides of the Bushings facing the
centre of the treadmill as shown in the inset drawing.
Insert two Handrail Bolts (78) with Handrail Washers
(77) into the Handrail Bushings (75), the right Upright
(69), and the right Handrail Spacer (65). Lift up the right
Handrail (66) to align the Bolts with the holes in the
Handrail. Next, thread the Bolts into the Handrail (66).
Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (78).
5
78
77
75
Thick
Side
69
66
65
75
77
6. Look at the Endcap (58). If the left or right foot on the
Endcap does not touch the floor, the included thick
base pads should be attached to the treadmill as de-
scribed below.
Refer to assembly step 3. Lower the treadmill frame
and the Uprights (69) as shown. If the left foot of the
Endcap (58) was off the ground, remove the two Base
Pads (99) from the right Upright (69). Attach the in-
cluded Thick Base Pads (not shown) to the Upright. If
the right side of the Endcap was off the ground, attach
the Thick Base Pads to the left Upright.
Note: If either side of the Endcap (58) lifts off the floor
when the treadmill is used, attach the Thick Base Pads
as described.
58
Right
Foot
Left
Foot
6
7
4. Place one of the Handrail Spacers (65) on the right
Upright (69) as shown, with the cutout turned toward the
treadmill (see inset drawing A). Pull the Upright Wire
Harness (98) up through the Handrail Spacer. Place the
other Handrail Spacer on the left Upright (not shown).
Have a second person hold the Handrails (66) near the
Uprights (69) as shown. Connect the Upright Wire
Harness (98) to the wires extending from the right
Handrail. Insert the connectors and the Wire Harness
(98) into the hole in the Console Base (81) (see inset
drawing B).
Be careful not to pinch the Wire Harness (98) as you set
the Handrails (66) on the Spacers (65).
4
98
69
66
81
65
69
65
81
98
A
B
Cutout