Filter
Top Products
17
When the cool-down segment is completed, the
walking belt will slow to a stop. After the fitness
test program is com-
pleted, your fitness level
will be shown in the
Time display. There are
ten fitness levelsÑ
fitness level 10 (FL:10)
is the highest. Remem-
ber, the fitness program is intended only to indicate
your relative fitness level.
Note: The Speed and Incline buttons will not
function while the fitness test program is selected. If
your pulse is not detected during the program, the
letters ÒPLSÓ will flash in the Heart Rate/Calories
display. If your pulse is not detected during the last
thirty seconds of any 4-minute segment (after 4
minutes, after 8 minutes, etc.), the fitness test pro-
gram will end and the Time display will show a fit-
ness level of 0 (FL: 0).
The fitness test program cannot be stopped tem-
porarily and then restarted. However, the program
can be stopped at any time by pressing the Stop
button. The Time display will then show an esti-
mated fitness level.
When the program has ended, remove the key.
Step onto the foot rails and make sure that the in-
cline of the treadmill is at 1%. The incline must
be at 1% when the treadmill is raised to the
storage position. Next, remove the key from the
console and put it in a secure place. Note: If the
displays and indicators on the console remain
lit after the key is removed, the console is in
the ÒdemoÓ mode. Refer to page 24 and turn off
the demo mode.
When you are finished using the treadmill, move
the on/off switch near the power cord to the off
position and unplug the power cord.
HOW TO USE THE PULSE-DRIVEN PROGRAM
The pulse-driven program automatically adjusts the
speed and incline of the treadmill to keep your heart
rate near a target level during your workout. Note: You
must wear the optional chest pulse sensor to use
the pulse-driven program (see page 24).
Follow the steps below to use the pulse-driven program.
Put on the chest pulse sensor.
Refer to the instructions included with the chest
pulse sensor to put on the chest pulse sensor.
Insert the key fully into the console.
See GETTING STARTED on page 10.
Select the pulse-driven program.
When the key is inserted,
the manual mode will be
selected and the Manual
indicator will light. To se-
lect the pulse-driven pro-
gram, press the Select
Program button repeat-
edly until the Pulse Driven indicator lights. When
the pulse-driven program is selected, the program
display will show a simplified profile of the program.
Enter your age.
When the pulse-driven
program is selected, an
age setting will flash in
the Incline display and
the letters ÒAGEÓ will ap-
pear in the Time display.
You must enter your age to use the pulse-driven
program. If you have already entered your age, go
to step 5. If you have not entered your age, press
the Enter Age buttons to enter your age. Four sec-
onds after the buttons are pressed, the age setting
will disappear from the display. Your age will then
be saved in memory.
4
3
2
1
6
Indicator
CAUTION: If you have heart prob-
lems, or if you are over 60 years of age and
have been inactive, do not use the pulse-driven
program. If you are taking medication regularly,
consult your physician to find whether the
medication will affect your exercise heart rate.