Filter
Top Products
4
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips screw-
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing is the key number of the part, from the PART LIST on page 21. The second number is the quantity
needed for assembly.
Note: Some small parts may have been pre-attached. If a part is not in the parts
bag, check to see if it has been pre-attached.
M10 x 63mm Bolt Set (62)–1
M6 x 36mm Button
Bolt (76)–4
M6 x 16mm Button
Screw (81)–4
M8 x 19mm Button
Screw (77)–4
M8 x 16mm Button
Screw (54)–6
M8 x 50mm Button
Screw (52)–4
M10 x 36mm Button
Screw (78)–4
M8 Split
Washer (55)–14
M4 x 16mm
Round Head
Screw (80)–4
M6 Nylon
Locknut (72)–4
M6 Washer
(88)–4
M4 x 22mm
Screw (60)–2
1. Attach the Left Front Stabilizer (15) to the left side of
the Frame (1) with three M8 x 16mm Button Screws
(54) and three M8 Split Washers (55).
Attach the Right Front Stabilizer (not shown) to the
right side of the Frame (1) in the same way.
15
54
1
1
55
55
54
17