Filter
Top Products
17
H
OW TO USE AN EVENT TRAINING PROGRAM
I
nsert the key into the console.
See HOW TO TURN ON THE POWER on page
1
5.
S
elect an event training program.
To select an event training program, press the
Event Training button repeatedly; the name of the
program and a track will appear on the screen.
Press the Start button to start the program.
A moment after the button is pressed, the walking
belt will begin to move at 3 mph. Hold the
handrails and begin walking.
Near the end of the second minute of the pro-
gram, the speed setting will flash on the screen
and a series of tones will sound. The speed of the
walking belt will then increase to 4 mph.
Near the end of the third minute of the program,
the speed setting will flash on the screen and a
series of tones will sound. The speed of the walk-
ing belt will then increase to 5 mph.
Near the end of the fourth minute of the program,
the speed setting will flash on the screen and a
series of tones will sound. The speed of the walk-
ing belt will then increase to 6.5 mph.
Note: To change the speed of the walking belt or
the incline of the treadmill at any time during the
program, press the Speed or Incline buttons.
During an event training program, the screen will
show the number of kilometers or miles still to be
run.
To stop the program at any time, press the Stop
button. To restart the program, press the Start but-
t
on. The walking belt will begin to move at 1 mph.
Adjust the speed of the walking belt as desired by
p
ressing the Speed increase or decrease button or
one of the numbered speed (MPH) buttons.
Note: When you have completed an event, your
t
otal time and the words “Cool Down” will appear
on the screen. If the speed of the walking belt was
greater than 5 mph when you completed the
event, the walking belt will then slow to 5 mph for
one minute. After one minute, the walking belt will
slow to 4 mph for 2 minutes. The walking belt will
then slow to 3 mph for 2 minutes. The walking belt
will then slow to a stop.
Select a display mode and follow your
progress with the exercise information on the
screen.
See step 5 on page 16.
Measure your heart rate if desired.
See step 6 on page 16.
Turn on the fan if desired.
See step 7 on page 16.
When you are finished exercising, remove the
key from the console.
When the program ends, make sure that the in-
cline of the treadmill is at the lowest setting.
Next, remove the key from the console and put it in
a secure place.
When you are finished using the treadmill,
switch the
reset/off circuit breaker to the “off”
position and unplug the power cord.
7
6
5
4
3
2
1