Filter
Top Products
7
2. Insert the Right Upright (74) into the indicated bracket on
the Base (83); be careful not to dislodge the Cage
N
uts (76) from the Right Upright (see the inset draw-
ing). In addition, be careful not to pinch the Upright
W
ire Harness (75). F
inger tighten three Upright Bolts
(72) with three Washers (78) and three Upright Star
Washers (71) into the Right Upright and the bracket.
Do
not tighten the Upright Bolts yet.
Repeat this step with the Left Upright (not shown). Note:
There is not a wire on the left side.
2
74
83
72
72
78
71
Bracket
71
75
78
76
4
5
48
3. Attach the Catch (5) to the left side of the Frame (48) with
two 3/4” Screws (4).
With the help of a second person, raise the Frame (48) to
a vertical position.
Be careful not to raise the Frame
past the vertical position. Have the other person hold
the Frame until step 5 is completed.
3
4. Hold the cylinder end of the Shock (88) near the bracket
in the center of the Frame (48).
See the two small inset drawings. Using your fingernail
or the end of a screwdriver, press on the end of the
Shock Pin (102) to loosen it from the Shock (88). Next,
rotate the Shock Pin and pull it out of the Shock. Be
careful to avoid losing the Shock Pin.
Orient the Shock (88) so it is in the position shown. Press
the end of the Shock onto the ball on the bracket.
See drawing 4a. Insert the Shock Pin (102) into the two
indicated small holes in the end of the Shock (88). Then,
rotate the Shock Pin until it clips onto the Shock. Note:
Extra Shock Pins are included.
102
48
88
Hole
Hole
102
88
4
4a
Bracket
Cylinder
Bracket
102
102