Filter
Top Products
10
If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1
.
M
ake sure that the power cord is unplugged.
R
emove
the indicated Screw (13) and the Access Door (70) from
the bottom of the Console Base (65).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Base (65). Hold the re-
ceiver so the small cylinder is oriented as shown.
Attach the receiver to the plastic posts on the Access
Door (70) with the two included small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (70) with the Screw (13). The other wires in-
cluded with the receiver may be discarded.
A
70
65
Small
Cylinder
13
Wire
Small
Screws