NordicTrack NTEL7506.2 Home Gym User Manual


 
11
13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
12. Apply a generous amount of grease to the axle
on the Left Upper Body Leg (24) and to the axle
on the left Crank Arm (55). Then, apply grease
to two Large Wave Washers (89).
Slide an Upper Body Leg Spacer (9) and a
Large Wave Washer (89) onto the Left Upper
Body Leg (24). Make sure that the flat side of
the Upper Body Leg Spacer is facing out-
ward. Slide the other Large Wave Washer (89)
onto the left Crank Arm (55).
With the help of another person, work the left
Pedal Arm (32) onto the Left Upper Body Leg
(24) and the left Link Arm (30) onto the left
Crank Arm (55) at the same time.
Attach the Pedal Arm (32) to the Left Upper
Body Leg (24) with an M8 x 20mm Patch Screw
(86), an Axle Cover (66), and an M8 x 23mm
Washer (31).
Then, attach the Link Arm (30) to the Crank Arm
(55) with an M8 x 20mm Patch Screw (86), a
Large Axle Cover (52), and an M8 x 23mm
Washer (31).
Repeat this step for the right Pedal
Arm (32) and the right Link Arm (30).
See step 4. Tighten the M8 x 20mm Button
Screws (85).
12
9
30
30
32
89
89
66
52
55
31
86
24
Grease
Grease
31
86
32