Filter
Top Products
6. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet
from damage, place a mat under the treadmill.
5. Insert two Handrail Bushings (94) into the right Upright
(83). Turn the Handrail Bushings so they fit against the
Upright as shown in the inset drawing.
Insert two Handrail Bolts (96) with Handrail Washers
(95) into the Handrail Bushings (94), the right Upright
(83), and the right Handrail Spacer (92). Lift up the right
Handrail (73) and align the Bolts with the holes in the
Handrail. Next, thread the Bolts into the Handrail. Do
not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (96).
5
96
95
94
83
73
92
94
95
7
3. With the help of a second person, carefully raise the
Frame (7) to the storage position and make sure that the
lock pin is properly engaged as described on page 25.
Position the Base Plate (115) on the treadmill as shown.
Attach the Base Plate with the three Base Plate Screws
(114). Note: It may be helpful if a second person tips the
treadmill slightly as you tighten the Screws.
Carefully lower the Frame (7) to the floor as described on
page 25.
115
7
114
3
4. Place one of the Handrail Spacers (92) on the right
Upright (83) as shown, with the cutout on the indicated
side (see inset drawing A). Pull the Upright Wire Harness
(131) up through the cutout. Place the other Handrail
Spacer on the left Upright (not shown).
Have a second person hold the Handrails (73) near the
Uprights (83) as shown. Connect the Upright Wire
Harness (131) to the wires extending from the right
Handrail. Insert the connectors and the Upright Wire
Harness (131) into the opening in the Console Base (79)
(see inset drawing B).
Set the Handrails (73) on the Handrail Spacers (92),
being careful not to pinch the Wire Harness (131).
131
83
73
79
92
79
A
B
4
131
92
Cutout