Filter
Top Products
7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet
from damage, place a mat under the treadmill.
7
6. Insert two Handrail Bolts (96) with Handrail Washers
(95) and Handrail Bushings (94) into the right Upright
(83) and the right Handrail Spacer (92). Turn the
Handrail Bushings (94) so they fit against the Upright as
shown in the inset drawing. Lift up the right Handrail
(73) and align the Bolts with the holes in the Handrail.
Next, thread the Bolts into the Handrail. Do not tighten
the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (96).
6
96
95
94
83
73
92
94
95
5. Place one of the Handrail Spacers (92) on the right
Upright (83) as shown, with the cutout on the indicated
side (see inset drawing A). Pull the Upright Wire Harness
(131) up through the cutout. Place the other Handrail
Spacer on the left Upright (not shown).
Have a second person hold the Handrails (73) near the
Uprights (83) as shown. Connect the Upright Wire
Harness (131) to the wires extending from the right
Handrail. Insert the connectors and the Upright Wire
Harness (131) into the opening in the Console Base (79)
(see inset drawing B).
Set the Handrails (73) on the Handrail Spacers (92),
being careful not to pinch the Wire Harness (131).
131
83
73
79
92
92
79
A
B
131
Cutout
5
4. Slide the Grounding Bracket (136) onto one of the
Handrail Spacers (92) in the location shown.
See inset drawing A. Pinch the tabs on the Grounding
Bracket (136) so that the tabs will fit into the hole in the
Upright (83) (see inset drawing B).
See inset drawing B. Place the Handrail Spacer (92) on
the left Upright (83) as shown, with the cutout on the indi-
cated side. Note: Make sure that the tabs on the
Grounding Bracket (136) (see inset drawing A) are in-
serted into the hole in the left Upright.
4
Tabs
A
B
83
136
136
92
92
Cutout