Filter
Top Products
7. In no less than a minute, press lever 5 (fig. 1) in the arrow
indicated direction in order to engage the stabilizing mode
and hold it in this position while observing.
ATTENTION! It is not allowed to engage the stabilizing mode
of the device when the power supply control
indicator is not glowing, or in less than a minute
after device has been turned ON.
When finishing the observation
release lever 5 (fig. 1). The lever should return to the initial
position. Now the stabilizing mode has been switched off.
Switch OFF the power supply unit.
5.3. Preparing the Device for Operation from On-board
Source
1. Replace the cartridge with batteries 1 (fig. 2) with a voltage
transformer available in the complete set of the device.
2. Connect the cable, supplied in the complete set, to the power
supply unit connector 2 (fig. 2).
3. Connect the device to the on-board power source.
4. Then prepare the device for operation as outlined in the
paragraph 5.2.
10
3. TECHNICAL CHARACTERISTICS
Magnification 16x
Angular field of view 3.4°
Exit pupil diameter, mm 2.5
Minimum focus, m 30
Interpupillary adjustment, mm: 58 – 72
Dioptric adjustment, not less, dptr
±5
Transmission factor, not less 0.55
Parallelism of eyepiece axes of sight:
- Divergence on vertical plane, not exceeding:
- Convergence on horizontal plane, not exceeding:
- Divergence on horizontal plane, not exceeding:
20’
20’
60’
Power source (batteries): 6 (AA)
From an on-board source, V 12
Angular velocity of panning in any
direction, degree/sec:
0 - 6
Stabilization freedom, degrees
±5
Overall dimensions, mm:
215×190×96
Weight (w/o batteries), kg, 1.98
Relative humidity (at +25°C) %: up to 98
Temperature range, °C
-30 ÷ +45
Temperature range during transportation,
o
C
-50 ÷ +50
7