Newcon Optik LRM1500 Binoculars User Manual


 
10
Changing battery
To install a battery:
Slide the battery compartment cover down (9, Fig. 2)
Install the battery observing polarity
Don’t apply superfluous strength while pushing the battery
inside the compartment.
Close the compartment cover
If the battery does not fit the compartment easily, it means that
polarity was reversed
To take a battery out:
Slide the battery compartment cover down (9, Fig. 2)
Shake the rangefinder gently towards the open end of the
battery compartment
Pull out the battery
The unit is fully operational when battery voltage is higher than
7V. A ‘LOW BATTERY’ warning is displayed when battery
voltage falls below 7.2V.
Ni-MH rechargeable or other 9V batteries capable to sustain
current drain up to 150 mA could be used to power the System.