-6-
S
E
T
/A
T
L
T
LAP
S/S
MODE
Average Speed
Trip Distance
Maximum
Heart Rate
Maximum Speed
Total Distance
Clock Time
(Current Speed)
Cadence
(Current Speed)
Elapsed Time
(S)(S)
C
Measurement screen map
Switching the lower display by
pushing MODE button.
Hold Down (2sec.)
Just Push
(2) Basic Operations
Start and stop measurement
Push S/S button and the unit will start measuring “Elapsed Time TM“. At the same
time, calculation of “Trip Distance DST“ and “Average Speed AVS“ starts. The symbol
of bpm in the middle display flashes while measuring. Push S/S button again and
the unit stops measuring and calculation. "Current Speed ", "Heart Rate ",
“Cadence ”, “Total Distance ODO“, “Maximum Heart Rate MXP“ and “Maximum
Speed MXS“ continue to be measured and displayed regardless of the start/stop.
Switching Functions
The upper display always shows “Current Speed ”, and the middle display always shows “Heart Rate ”. In
the lower display, the selected function is displayed. Push MODE button to switch functions of the lower display.
As illustrated below, the lower display changes as TM (Elapsed Time) –> Cadence C –> Clock –> AVS (Average
Speed) –> Dst (Trip Distance). These five functions are called “Main functions”, and each Main function has its
corresponding Sub function. (Cadence does not have Sub function.) To switch from one Main function to its sub
function, hold down MODE button. To go back to Main function, push MODE button. You can not switch the Sub
function to one another.
