Filter
Top Products
Assembly
NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled.
Step 1
Attach the U-Shaped Base (#2) to Main Frame (#1) using:
• two M12*80 Button Head Cap Screw (#19)
• four Φ13*Φ26*2 Flat Washer (#13)
• two M12 Nylon Lock Nut (#14)
Attach the Rear Base (#3) to Main Frame (#1) using:
• two M12*75 Button Head Cap Screw (#15)
• four Φ13*Φ26*2 Flat Washer (#13)
• two M12 Nylon Lock Nut (#14)
Attach the Knob Bolt (#26) into Main Frame (#1). This Knob is used to tighten down any attachment
used in your XM-7604 Bench.
6