Filter
Top Products
Engineering Mode
Press STOP and then Speed Up to enter the
Engineering Mode.
Press Enter / Mode
Guard automatically pauses the unit if it detects the
treadmill is not being walked on. Press Speed/Incline
Up/Down buttons
Press Enter / Mode to show Roller diameter
Press Enter / Mode to set up the units of measurement
in Metric (SI) or in English (EN).
Press Speed/Incline or Up/Down to change
Press Enter / Mode
for Distance
This is the total distance the treadmill has been run
in Miles or Kilometers depending on what mode the
treadmill is in.
Press Enter / Mode for Workout Time
This is the total number of hours the treadmill
has been used.
Press Enter/Mode again to return to the standby mode.
150
Roller
625
En or Si
Total Distance
0 000
0 000
Total Hours
Set Calendar On
Press Enter / Mode to set up Calendar
Calendar Operation:
Engineering Mode
Intelli-Guard On
Select the units
44
(incline window shows software version)
2009.06.18
Press STOP and then SPEED UP to enter the Engineering Mode. You can press ENTER/MODE to
switch setup screens, or press STOP+SPEED UP to return to Standby Mode. The table below
shows the sequence of the setup screens.
Information viewed on screen
Engineering function