Filter
Top Products
General Specifications
1. Frame Construction
Frame is constructed of mechanical quality steel purchased in mill run quantities.
Frame is primarily 2 ½" x 4 ½" oval-shaped tubing with 11 gauge wall thickness.
2. Frame Finish
Prior to applying finish, each part is chemically washed to prepare surface for maximum adhesion.
3. Bolts
All hardware is metric and has a corrosion resistant finish.
4. Upholstery
Contoured pads.
All edges are stitched to eliminate any folds in the material that would limit durability.
5. Foam
Three and four pound EVA foam (deformation resistant) or equivalent is used on all machines. The foam is injection molded directly to the multi-
ply wood support board with integral 10mm T-nuts.
6. Hand Grips
Hand grips are an extruded 60-durometer-thermorubber compound that is non-absorbing, wear and tear resistant, and exhibits good dry and wet
frictional characteristics.
The grips are retained with aluminum collars, which eliminate the tendency of the grips to slide off the handle.
7. Foot Platforms
Foot platforms are molded rubber with a slip resistant texture.
8. Equipment Anchoring
All machines have holes in the feet, which allow for easy anchoring to the floor. Life Fitness recommends that all machines be anchored to the
floor to minimize the possibility of tipping.
9. Warranty
10-year minimum warranty on frames, 5 years on integral bearings, 1 year on grips, and 90 days on upholstery and any items not specified.
10. Liability Insurance
Certificate of insurance available upon request.
Leg Raise
3. Specifications
8