Filter
Top Products
13
STEP 8:
Insert two 3/4” x 1” BUSHINGS (36) to the of the PAD HOLDER ASSEMBLY (4). Insert one 1/2” x 5.29” SHAFT (35)
through the 3/4” x 1” BUSHINGS (36).
Insert two 3/4” x 1” BUSHINGS (36) to the ends of the MAIN FRAME ASSEMBLY (1). Insert the remaining 1/2” x
5.29” SHAFT (35) through the 3/4” x 1” BUSHINGS (36).
Attach the BACKREST SUPPORTS (5) to the MAIN FRAME ASSEMBLY (1) and the PAD HOLDER ASSEMBLY (4)
using two M10 x 20mm SCREWS (22) and two FLAT 3/8” WASHERS (19) each. Finger tighten the screws.
NOTE: THE BACKREST SUPPORTS (5) SHOULD BE ORIENTED TOWARDS THE MAIN FRAME ASSEMBLY (1) AS
SHOWN.
Attach the BACKREST SUPPORT BRACE (23) between the BACKREST SUPPORTS (5) using two M10 x 20mm
SCREWS (22) and two FLAT 3/8” WASHERS (19). Tighten all screws securely.