Filter
Top Products
Lat Pulldown
Assembly Instructions
1. LOOSELY assemble the FRONT BRACE (1) and REAR BRACE (2) to the
TOWER (3) using four M10 X 130mm BOLTS (4), eight 3/8" SAE WASH-
ERS (5) and four M10 NYLOCK NUTS (6) as shown.
2. LOOSELY assemble the SEAT FRAME (7) to the FRONT BRACE (1) and
REAR BRACE (2) using four M10 X 90mm BOLTS (8), eight 3/8" SAE
WASHERS (5) and four M10 NYLOCK NUTS (6) as shown.
3. LOOSELY assemble the TOP BRACE (9) to the SEAT FRAME (7) and
TOWER (3) using two M10 X 90mm BOLTS (8), four 3/8" SAE WASHERS
(5) and two M10 NYLOCK NUTS (6) at the SEAT FRAME and two M10 X
70mm BOLTS (10), four 3/8" SAE WASHERS (5) and two M10 NYLOCK
NUTS (6) at the TOWER as shown.
4. LOOSELY assemble the ROLLER PAD BRACKET (11) to the SEAT FRAME
(7) using two M10 X 35mm BOLTS (12), four 3/8" SAE WASHERS (5) and
two M10 NYLOCK NUTS (6) as shown.
5. Tighten all BOLTS and NUTS securely.
6. Install the PIVOT SHAFT (13), LONG SPACER (14), two BEAR-
INGS (15), two SHORT SPACERS (16) and two BEARING CAPS
(17) into the PIVOT HOUSING (A) of the SEAT FRAME (3).
7. Assemble the WORKARM (18) to the PIVOT HOUSING (A) using
two M10 X 25mm BOLTS (19) as shown. Tighten the BOLTS
securely.