Filter
Top Products
7
STEP 1:
Slide the RIGHT SUPPORT LEG (55) over the MOUNTING TUBE (A) of the RIGHT UPRIGHT (4). Loosely secure
the RIGHT SUPPORT LEG (55) and RIGHT UPRIGHT (4) to the FRONT UPRIGHT (1) using two M12 x 80mm
SCREWS (60), four 1/2” WASHERS (61), and two M12 HEX NYLOCK NUTS (62) as shown.
With the UPPER PULLEY ASSEMBLY (25) oriented as shown, insert the UPPER PULLEY ASSEMBLY (25) into the
top of the RIGHT UPRIGHT (4) and secure together the RIGHT UPRIGHT (4), FRONT UPRIGHT (1), and UPPER
PULLEY ASSEMBLY (25) using two M10 x 30mm SCREWS (58) and two FLAT 3/8” WASHERS (57).
Repeat the above steps to assemble the LEFT UPRIGHT (5) and LEFT SUPPORT LEG (56) to the FRONT
UPRIGHT (1).
NOTE: THE TOP PULLEY WELDMENT ATTACHES TO THE INSIDE OF THE UPRIGHT SIDES AND THE ORIENTA-
TION SHOULD BE AS SHOWN.
Mid Pulley Covers - See Attached
Front Cover
8317301
Rear Cover
8263501
Top Cover
8263401