Filter
Top Products
2
How To...REMOVE AND REPLACE THE LIFEPULSE
DIGITAL HEART RATE SENSORS
Tools Required: Phillips screwdriver, standard screwdriver, 5/64” hex key wrench
Installing the new Lifepulse digital heart rate sensors:
Step 4
Plug the Faston connector (red or white wire) to the back of the new, pre-assembled signal output sensor assembly
(this will be the assembly without the screw access holes in the sensor) and locate it into position. This sensor will be
the sensor on which the palm rests during use.
Step 5
Plug the Faston connector (black or green wire) to the back of the new, pre-assembled ground sensor assembly (this
will be the assembly with the screw access holes in the sensor) and locate it into position. This is the sensor on
which the fingertips rest during use.
Step 6
Install the two screws through the access holes in the ground sensor and torque to 5 - 7 In. Lb. .
Step 7
Repeat Steps 1 through 6 to remove and replace the second set of sensors included in the kit.
The installation is now complete.
Kit Number Product
GK20-00002-0001 Life Fitness 9100HR and 9500HR Treadmills
( small radius ) Life Fitness 9500HR Cross-Trainer Total Body
Lifecycle 6500HR Exercise Bike
Lifecycle 8500 Exercise Bike
GK20-00002-0002 Life Fitness 9500HR Stairclimber
( large radius ) Lifecycle 9500HR Exercise Bike
Lifecycle 9500HR Recumbent Exercise Bike
M051-00K20-A015