Filter
Top Products
7
STEP 4:
FIGURE 4
• Slide one GUIDE ROD (10) through the upper hole in the UPRIGHT (1 & 16) and proceed to slide one 1” SHAFT COLLAR (6)
over the bottom of the GUIDE ROD (10) as shown in FIGURE 4.
• Hook the SMITH BAR (7) onto slots of the BAR SUPPORT RACKS (8).
4
6
10
1
5
• CAREFULLY lower the GUIDE ROD (10) through the HOUSING (4) on the SMITH BAR (7). (NOTE: Allow the GUIDE
RODS (10) to push the plastic insert out the bottom of the HOUSINGS (4). Discard these inserts.)
• Insert the GUIDE ROD (10) into the bottom hole of the UPRIGHT (1 & 16). Repeat this step on the other side.
• CAREFULLY slide one BAR STOP (5) over the end of the GUIDE ROD (10). Hook BAR STOP (5) into the slots of BAR
SUPPORT RACKS (8) as shown.
16
8
7