Life Fitness Classic Series Elliptical Trainer User Manual


 
1.
Locate the BOTTOM COVER (#6). Position the cover as
shown with the notch of the center hole facing downward.
Slide the BOTTOM COVER down over the UPPER CONSOLE
SUPPORT TUBE (A) until it rests against the FRONT TUBE
EXTENSION (B).
2.
Position the HANDLEBAR (#11) as shown near the UPPER
CONSOLE SUPPORT TUBE (A).
3.
Connect the 4-PIN HEART RATE CONNECTOR (4P) leading
from the HANDLEBAR (#11) center to the 4-PIN HEART
RATE CONNECTOR (4P) leading from the UPPER
CONSOLE SUPPORT TUBE (A).
4.
Carefully slide the HANDLEBAR MOUNTING FLANGES (C)
into the UPPER CONSOLE SUPPORT TUBE (A).
NOTE: BE CAREFUL NOT TO PINCH THE HEART RATE
CABLE WHEN INSERTING THE HANDLEBAR FLANGES (C)
INTO THE UPPER CONSOLE SUPPORT TUBE (A).
5.
Secure the HANDLEBAR (#11) to the UPPER CONSOLE
SUPPORT TUBE (A) using four MOUNTING BOLTS (#1).
Tighten the SCREWS to 15-20 ft. lbs.
6.
Insert the POLAR RECEIVER (#13) into the polar receiver
receptacle located at the center of the UPPER CONSOLE
SUPPORT TUBE (A). Slide the POLAR RECEIVER SLEEVE
(#14) over the POLAR RECEIVER covering the entire POLAR
RECEIVER.
7.
Locate the TOP COVER (#5). Slide the BOTTOM COVER
(#6) upward toward the HANDLEBAR (#11) until it contacts
the HANDLEBAR. Position the TOP COVER over the POLAR
RECEIVER (#13) and HANDLEBAR and align it to the
BOTTOM COVER. Secure the TOP COVER to the BOTTOM
COVER using four PHILLIPS SCREWS (#2) as shown.
8.
Align the ACCESSORY TRAY (#3) to the bottom of the
DISPLAY CONSOLE (#4) as shown. Secure the
ACCESSORY TRAY to the DISPLAY CONSOLE using four
PHILLIPS SCREWS (#2).
9.
Position the DISPLAY CONSOLE (#4) above the MOUNTING
BRACKET (D) as shown. Attach all CONNECTORS (E)
leading from the DISPLAY CONSOLE MOUNTING BRACKET
to the corresponding CONNECTORS located on the back of
the DISPLAY CONSOLE.
10.
Attach the DISPLAY CONSOLE (#4) to the DISPLAY
CONSOLE MOUNTING BRACKET (D) using four SCREWS
(#2).
NOTE: BE CAREFUL NOT TO PINCH ANY CABLES WHEN
SECURING THE DISPLAY CONSOLE (#4) TO THE DISPLAY
CONSOLE MOUNTING BRACKET (D).
Tighten the screws securely.
2
3
4
2
14
6
C
5
13
A
4P
4P
D
E
11
B
1
1
2CX