Filter
Top Products
8. There is a large hole in the rear of the display console (#6)
through which you can see a 10-pin connector and a 4-pin
connector. These correspond to the matching connectors on
the wire harness protruding from the top of the handlebar.
Model C7i Only: Properly align the locking tabs of the 16-PIN
CONNECTOR (16P) on the WIRE HARNESS with the 16-PIN
CONNECTOR on the back of the DISPLAY CONSOLE, then
snap them together. Next, align the locking tabs of the 3-PIN
CONNECTOR (3P) on the WIRE HARNESS with the 3-PIN on
the back of the DISPLAY CONSOLE and plug them together
until they SNAP into place.
Model C9i Only: Properly align the locking tabs of the 10-PIN
CONNECTOR (10P) on the WIRE HARNESS with the 10-PIN
CONNECTOR on the back of the DISPLAY CONSOLE, then
snap them together. Next, align the locking tabs of the 4-PIN
CONNECTOR (4P) on the WIRE HARNESS with the 4-PIN on
the back of the DISPLAY CONSOLE and plug them together
until they SNAP into place.
9. Feed the WIRE HARNESS back into the HANDLEBAR TUBE.
Attach the DISPLAY CONSOLE (#6) to the HANDLEBAR
ASSEMBLY using the four CONSOLE SCREWS (#2) and a
Phillips screwdriver. Tighten the four SCREWS in a crisscross
pattern.
CAUTION!: BE CAREFUL NOT TO OVERTIGHTEN
THE SCREWS.
10. To install the 9-VOLT ALKALINE BATTERY (#8) found in the
parts bag use a Phillips screwdriver to remove the screw from
the back door. Gently pull the BATTERY WIRES from the back
of the DISPLAY CONSOLE and connect them to the 9-VOLT
ALKALINE BATTERY. Carefully, tuck the BATTERY WIRES
back into the DISPLAY CONSOLE and set the BATTERY in
place.
Re-install the BATTERY DOOR by inserting the bottom tab of
the BATTERY DOOR into the corresponding slot in the
DISPLAY CONSOLE. Push the DOOR into place and tighten
the screw with a Phillips screwdriver.
CAUTION!: BE CAREFUL NOT TO OVER TIGHTEN THE SCREW
11. After placing the Lifecycle exercise bike in the intended location
for use, check the stability of the bike.
If the bike is not level, rotate the FOOT in the STABILIZER BAR
that appears to be higher until the Lifecycle is level.
Secure the position of the FOOT by tightening the LOCKNUT
with the enclosed wrench.
6
10P
4P
3P
16P
E
D
8
FOOT