Filter
Top Products
7
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
FIGURE 6
STEP 6:
• Insert two GUIDE RODS (6) into the STACK
BASE (3) as shown in FIGURE 6. Lubricate the
GUIDE RODS (6) with a silicon or teflon
spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (26)
down over the GUIDE RODS (6). See FIGURE 6.
• Using EXTREME CARE slide twenty WEIGHT
PLATES (40) down over the GUIDE RODS (6)
with the key-hole facing as shown in FIGURE 6.
• Apply one set of WEIGHT STACK LABELS -
1-26 (41) to each WEIGHT PLATE (40) as
shown in FIGURE 6.
• Slide two 13/16” SHAFT COLLARS (15) over
the GUIDE RODS (6) as shown in FIGURE 6.
6
40
26
3
41
15
• Carefully Slide the HEAD PLATE ASSEMBLY
(39 & 40) down over the GUIDE RODS (6)
onto the weight stack as shown in FIGURE 6.
HEAD PLATE
ASSEMBLY