Filter
Top Products
21
FIGURE 20
STEP 20
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
• Insert the PUSH/PULL CABLE through the bottom of the PRESS ARM (27) up to the CONTROL LEVER (60) and hold in place with
one E-RING (56) as shown in FIGURE 20.
• SECURELY assemble the PUSH/PULL CABLE to the CONTROL LEVER (60) using one 3/8” JOINT CONNECTOR CAP (57),
one #10 FLAT WASHERS (59), and one 8-32 X 3/16 IN. SCREWS (58) as shown in FIGURE 20.
• Slide one 4” VINYL SLEEVE (47) over the CONTROL LEVER (60). Then SECURELY assemble the CONTROL LEVER (60) to the TAB
on the PRESS ARM (27) using one 3/8” JOINT CONNECTOR CAP (57), one #10 FLAT WASHERS (59), and one 8-32 X 3/16
IN. SCREWS (58) as shown in FIGURE 20.
59
PUSH/PULL
CABLE
27
58
60
57
56
47