Filter
Top Products
SPRING PIN ADJUSTMENT
FIGURE 14
STEP 14
The 832 LEG PRESS is equipped with a springpin adjustment to acconunodate differen! sized users and allow easy entry and exit
from the machine. To use, you must slightly push against the foot plates to take tension off the pin.
To set the correct amo~mt of tension in the cables, adjust the 832 LEG PRESS into the last adjustment hole (so the LEG PRESS
is spread apart) and remove the WEIGHT STACK PIN. Thread the 112-3/4" CABLE (16) into the HEAD PLATE ASSEMBLY
until the PULLEY BRACKET (2) is held against the TOP BOOM and the cable is slightly pulling up on the HEAD PLATE.
Tighten the jan but securely. Next, thread the 82-1/2" CABLE (17) into the PULLEY BRACKET (2) until cable is tight,
tighten the jam nut securely.
THIS CONCLUDES THE ASSEMBLY OF THE 415101 LEG PRESS ADAPTER KIT
3
4 5 6
0 1 ] I I I
10